Sharp MX-B355W User Manual page 190

COPIER►OTHER FUNCTIONS
3
Erase
Up
Left Right
Down
Specify the erase edge on the reverse side when erasing edges of one to three sides of Up, Down, Left, and Right on
the front side to scan a 2-sided original.
• If the [Reverse erase position of back face] checkbox is set to
edge on the front side will be erased.
• If the [Reverse erase position of back face] checkbox is set to
will be erased.
Specify the erase width.
4
Tap the numeric value display indicating the margin shift area on the front side or reverse side, and enter the area using
the numeric keys.
After the settings are completed, tap
To quickly set the area, first specify a value close to the desired value by the numeric keys, then adjust it with
• To cancel the erase setting:
Tap the [Clear] key.
• To cancel all settings:
Tap the [CA] key.
Tap the [Start] key to start copying.
5
Clear
Outer Frame
Specify Frame+Center
Reverse erase position of
back face
8½x11
8½x11
and [Back] keys in sequence.
2-71
Tap the checkbox of the edge that you
wish to erase, and specify the erase
position.
Check that he tapped checkbox is set to
If the [Outer Frame] key is tapped, the [Up], [Down], [Left],
and [Right] checkboxes are set to
If the [Specify Frame+Center] key is tapped, all the
checkboxes are set to .
, the edge in the position opposite to the erased
, the edge in the same position as on the front side
.
.
.