Erasing Peripheral Shadows For Copying (Erase) - Sharp MX-B355W User Manual

COPIER►OTHER FUNCTIONS
ERASING PERIPHERAL SHADOWS FOR COPYING
(ERASE)
The erase function is used to erase shadows around the edges of copies that occur when copying thick originals or
books.
When a thick book is copied
Shadows appear here
Erase modes
Outer Frame Erase
• If a ratio setting is used in combination with an erase setting, the erase width will change according to the selected ratio. If
the erase width setting is 1" (20 mm) and the image is reduced to 50%, the erase width will be 1/2" (10 mm).
• This function erases the parts of the image where shadows tend to form, but does not detect shadows and erase only the
shadows.
• When Erase is selected, the orientation of the original is automatically set to portrait.
To change the default erase width setting:
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Condition Settings] → [Erase Width Adjustment].
The factory default setting is 1/2" (10 mm). The changed setting is also applied to the Setting mode selection of [System
Settings] → [Image Send Settings] → [Common Settings] → [Condition Settings] → [Erase Width Adjustment].
Place the original.
1
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
► AUTOMATIC DOCUMENT FEEDER (page 1-75)
► DOCUMENT GLASS (page 1-77)
Tap the [Others] key, and tap the [Erase] key.
2
Center Erase
2-70
Not using the Erase
Shadows appear on the
copy
Edge + Center Erase
Using the Erase
Shadows do not appear on
the copy
Side Erase