Brocade Communications Systems FastIron SX 800 Diagnostic Manual page 45

=================== Remote CCEP UP ===================
CLUSTER FSM: Received CCRR message from peer when CCP is up
CLUSTER FSM: cluster id 1, client id 300, old state: Local Up, event: Remote Up
CLUSTER FSM: Cluster ABC (Id: 1), client c1 (RBridge Id: 300) - Remote client CCEP
up
CLUSTER FSM: new state: Up, master: FALSE
===================== CCP Down ============================
CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: CCP Down, event: CCP
Down
CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: CCP Down, event: CCP
Down
CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: CCP Down, event: CCP
Down
CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: CCP Down, event: CCP
Down
======================== CCP getting established ==========================
CLUSTER FSM: new state: Loading
CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: Loading, event: CCP Up
CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: Loading, event: CCP Up
CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: Loading, event: CCP Up
CLUSTER FSM: Received Loading-Done message from peer
CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: Loading, event: Loading
Done
CLUSTER FSM: getting EVENT_ID_MCT_CCP_UP event
CLUSTER FSM(T=121842)main: cluster id 1, client id 300, old state: Init, event:
CCP Up
CLUSTER FSM(T=121842)main: new state: Local Deploy, master: FALSE
CLUSTER FSM: new state: CCP Up
CLUSTER FSM: Received CCRR message from peer when CCP is up
CLUSTER FSM: cluster id 1, client id 300, old state: Local Deploy, event: Remote
Deploy
CLUSTER FSM: Cluster ABC (Id: 1), client c1 (RBridge Id: 300) - Remote client
deployed
CLUSTER FSM: new state: Admin Up, master: FALSE
CLUSTER FSM: Received CCRR message from peer when CCP is up
If the debug cluster fsm client command is disabled, the output similar to the following is displayed.
Brocade# no debug cluster fsm client 300
CLUSTER fsm debugging is now OFF for client rbridge 300
debug cluster intf-mac
Syntax: [no] debug cluster intf-mac
This command displays interface MAC debug information for the cluster as shown in the following
example.
Brocade# debug cluster intf-mac
CLUSTER ROUTER MAC(T=1791244): sent to peer rbridge id 2, base mac address
0000.0021.a500, number of mac addresses 1
CLUSTER ROUTER MAC(T=1791244): received from peer rbridge id 2, router mac address
0000.0083.3200, number of mac addresses 1
debug cluster mdup
Syntax: [no] debug cluster mdup
This command displays MDUP debug information for the cluster as shown in the following example.
Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference
53-1002965-01
MCT debug commands
3
33