Table of Contents
Advertisement
2.2 Bluetooth Pairing a KDC185 to your smart device with special barcodes
a. Navigate to the Bluetooth setting on the host device and ensure that Bluetooth is both
enabled and searching for devices.
b. Using the KDC, scan the pairing barcode above that corresponds to your desired
Bluetooth profile. If you are unsure which Bluetooth profile is right for you, please refer
to
Chapter section
•
If you use an Android, iOS, or Mac device and desire an HID connection, then scan
barcode #1 above.
•
If you use a Windows device and desire an HID connection, then scan barcode #2
above.
•
If you desire an SPP connection for any device, then scan barcode #3 above.
c. In HID or HID Windows Profile, check the list of available Bluetooth devices on your host
device. From the list, select the KDC185 listed by serial number in brackets that matches
the serial number found on the back side of the KDC185. KDC185 will beep upon
connection and display "BLE HID Connected" on its screen. Now it is ready to use.
d. In SPP Profile for non-iOS, check the list of available Bluetooth devices on your host
device. From the list, select the KDC18 5 listed by serial number in brackets that matches
the serial number found on the back side of the KDC185. KDC185 will beep upon
connection and display "BLE SPP Connected" on its screen, but you should launch
KTSync or your application and select KDC18 5 within the application to complete the
connection. Now it is ready to use.
See Reference Manual for more detailed information
Visit
store.koamtac.com
Bluetooth Profile & Pairing
#1. HID-BLE & Pairing (Android, iOS, Mac)
#2. HID-Windows & Pairing (Windows)
#3. SPP-BLE & Pairing (Android, iOS, Mac, Windows)
2.1.
to purchase additional KDCs and accessories.
KDC185 QG
Quick Guide
QG_KDC185_20220614 p4
Advertisement
Table of Contents
