Connecting StackWise Cable to StackWise Ports
Connecting StackWise Cable to StackWise Ports
Step 1
Step 2
Step 3
Step 4
Catalyst 3750 Switch Hardware Installation Guide
3-38
Run the setup program. See the
•
page
C-11.
Connect to the front-panel ports. See the
•
10/100/1000 Ports" section on page
Module" section on page
section on page 3-59
To use the CLI, enter commands at the Switch> prompt through the console port
by using a terminal program or through the network by using Telnet. For
configuration information, refer to the switch software configuration guide or the
switch command reference.
Follow these steps to connect the StackWise cable to the StackWise ports:
Remove the dust covers from the StackWise cables and StackWise ports, and store
them for future use.
Insert one end of the StackWise cable into the StackWise port on the back of the
switch.
Always use a Cisco-approved StackWise cable to connect the switches.
Note
Use the window in the StackWise cable to align the connector correctly. Secure
the screws tightly.
Insert the other end of the cable into the connector of the other switch, and secure
the screws tightly.
Removing and installing the StackWise cable can shorten its useful life.
Caution
Do not remove and insert the cable more often than is absolutely
necessary.
"Completing the Setup Program" section on
"Connecting to the 10/100 and
3-51, the
3-55, and the
"Connecting to a XENPAK Module"
to complete the installation.
Chapter 3
Switch Installation
"Connecting to an SFP
78-15136-03