Powering On The Switch - Cisco Catalyst 3750 Hardware Installation Manual

Powering On the Switch

Powering On the Switch
Step 1
Step 2
Catalyst 3750 Switch Hardware Installation Guide
1-4
Complete these steps to power on the switch:
Connect one end of the AC power cord to the power connector on the switch rear
panel, as shown in Figure
Figure 1-3 Connecting the Power
S TA C K
1
CO NS O
S TA C K LE
2
2
1 Switch 2
Connect the other end of the power cable to a grounded AC outlet.
As the switch powers on, it begins the power-on self-test (POST), a series of tests
that runs automatically to ensure that the switch functions properly. POST lasts
approximately 1 minute.
1-3.
DC IN
PU TS
FO R RE
PO W ER MO TE
RA TI NG
SP EC IF SU PP LY
10 0- 24 IE D IN
0V ~ MA NU
1.2 A- 0>
+1 2v AL
6A , 50
@ 13 A
-6 0 HZ
AC power cord
Chapter 1 Using Express Setup
1
78-15136-03