Entering The Initial Configuration Information - Cisco Catalyst 3750 Hardware Installation Manual

Appendix C Configuring the Switch with the CLI-Based Setup Program

Entering the Initial Configuration Information

IP Settings
Completing the Setup Program
Note
Step 1
78-15136-03
To set up the switch, you need to complete the setup program, which runs
automatically after the switch is powered up. You must assign an IP address and
other configuration information necessary for the switch to communicate with the
local routers and the Internet. This information is also required if you plan to use
the Cluster Management Suite (CMS) to configure and manage the switch.
You will need this information from your network administrator before you
complete the setup program:
Switch IP address
•
Subnet mask (IP netmask)
•
Default gateway (router)
•
Enable secret password
•
Enable password
•
Telnet password
•
If your switches are stacked and there are multiple console connections to
individual switches in the stack, the initial setup dialog appears in the first console
where the user presses Enter.
Follow these steps to complete the setup program and to create an initial
configuration for the switch:
Enter Yes at the following two prompts.
Entering the Initial Configuration Information
Catalyst 3750 Switch Hardware Installation Guide
C-11