Chapter 3
Switch Installation
Figure 3-42 Installing a XENPAK Module in the Catalyst 3750G-16TD Switch
T X
R X
1
2
1
Optical bore dust plug
Step 6
Removing a XENPAK Module
Step 1
Step 2
Step 3
Step 4
78-15136-03
2
Captive installation screw
Secure the XENPAK module in place by tightening the two captive installation
screws. Do not overtighten the captive screws.
To remove a XENPAK module, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on
the chassis.
Disconnect the cable from the XENPAK module. For fiber-optic modules, install
the optical bore dust plugs.
Loosen the two captive installation screws that secure the XENPAK module in the
slot.
Carefully pull on the two captive installation screws to disconnect the XENPAK
module from the slot.
Installing and Removing XENPAK Modules
C a ta ly s t 3
1
Catalyst 3750 Switch Hardware Installation Guide
7 5 0
s e ri e s
3-49