Connecting Stackwise Cable To Stackwise Ports; Table- Or Shelf-Mounting - Cisco Catalyst 3750 Hardware Installation Manual

Connecting StackWise Cable to StackWise Ports

For configuration instructions about using the CLI setup program, go to
Switch with the CLI-Based Setup Program."
To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
program or through the network by using Telnet. For configuration information, see the switch software
configuration guide or the switch command reference.

Table- or Shelf-Mounting

Follow these steps to install the switch on a table or shelf:
Locate the adhesive strip with the rubber feet in the mounting-kit envelope. Attach the four rubber feet
Step 1
to the recessed areas on the bottom of the unit.
Place the switch on the table or shelf near an AC power source.
Step 2
After the switch is mounted on the table, you might need to perform these tasks to complete the
installation, run the setup program, and access the switch:
•
•
•
•
For configuration instructions about using the CLI setup program, go to
Switch with the CLI-Based Setup Program."
To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
program or through the network by using Telnet. For configuration information, see the switch software
configuration guide or the switch command reference.
Connecting StackWise Cable to StackWise Ports
Follow these steps to connect the StackWise cable to the StackWise ports:
Remove the dust covers from the StackWise cables and StackWise ports, and store them for future use.
Step 1
Insert one end of the StackWise cable into the StackWise port on the back of the switch.
Step 2
(See
Note
Catalyst 3750 Switch Hardware Installation Guide
2-32
(Optional) Connect the switches in the stacks. See the
Ports" section on page 2-32.
Power on the switch. See the
stacked, see the "Planning Considerations" section on page 2-9
considerations.
Connect to a 10/100 or 10/100/1000 port and run Express Setup. See the Catalyst 3750 Switch
Getting Started Guide for instructions.
Connect to the front-panel ports. See the
on page 2-41 and the "Connecting to an SFP Module" section on page 2-43
installation.
Figure 2-44.)
Always use a Cisco-approved StackWise cable to connect the switches.
"Connecting StackWise Cable to StackWise
"Verifying Switch Operation" section on page
"Connecting to the 10/100 and 10/100/1000 Ports" section
Chapter 2 Switch Installation
Appendix D, "Configuring the
2-7. If the switches are
for information on powering
to complete the
Appendix D, "Configuring the
OL-6336-06