Connecting To A Fiber-Optic Sfp Module - Cisco Catalyst 3750 Hardware Installation Manual

Connecting to an SFP Module

Connecting to a Fiber-Optic SFP Module

Caution
Step 1
Step 2
Step 3
Step 4
Catalyst 3750 Switch Hardware Installation Guide
3-56
Follow these steps to connect a fiber-optic cable to an SFP module:
Do not remove the rubber plugs from the SFP module port or the rubber caps from
the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the SFP module ports and cables from contamination and ambient light.
Before connecting to the SFP module, be sure that you understand the port and
cabling stipulations in
"SFP Module Slots" section on page
Cable Specifications"
Remove the rubber plugs from the module port and fiber-optic cable, and store
them for future use.
Insert one end of the fiber-optic cable into the SFP module port (see
Insert the other cable end into a fiber-optic receptacle on a target device.
Observe the port status LED.
The LED turns green when the switch and the target device have an established
link.
The LED turns amber while the STP discovers the network topology and searches
for loops. This process takes about 30 seconds, and then the port LED turns green.
If the LED is off, the target device might not be turned on, there might be a cable
problem, or there might be problem with the adapter installed in the target device.
See Chapter 4, "Troubleshooting,"
"Installation Guidelines" section on page 3-7
2-12. See
for information about the LC on the SFP module.
for solutions to cabling problems.
Chapter 3 Switch Installation
and in the
Appendix B, "Connector and
Figure 3-46).
78-15136-03