Ports - Cisco Catalyst 3750 Hardware Installation Manual

Front Panel Description
Note
Figure 2-8 Catalyst 3750G-16TD Switch Front Panel
SY ST
RP S
1
MA STR 2
3 4
STA T 1X 5
6
7 8
DU PLX
9 10
SP EE D 11
STA CK
MO DE
2X
1
1

10/100/1000 ports

10/100 Ports
Catalyst 3750 Switch Hardware Installation Guide
2-8
The 10/100/1000 ports on the Catalyst 3750G-16TD switch are grouped in pairs.
The first member of the pair (port 1) is above the second member (port 2), as
shown in Figure 2-8. Port 3 is above port 4, and so on. The XENPAK module slot
is numbered 1.
The 10-Gigabit Ethernet XENPAK modules are referred to as 10-Gigabit Ethernet
module ports in the software documentation.
12
13 14
15 16
15X
16X
2
XENPAK module slot
You can set the 10/100 ports on the Catalyst 3750 switches to operate in any
combination of half duplex, full duplex, 10 Mbps, or 100 Mbps. You can also set
these ports for speed and duplex autonegotiation, in compliance with
IEEE 802.3ab. (The default setting is autonegotiate.) When set for
autonegotiation, the port senses the speed and duplex settings of the attached
device and advertises its own capabilities. If the connected device also supports
autonegotiation, the switch port negotiates the best connection (that is, the fastest
line speed that both devices support and full-duplex transmission if the attached
device supports it) and configures itself accordingly. In all cases, the attached
device must be within 328 feet (100 meters).
Ca tal ys t 37
50
se rie s
1
TX
RX
2
Chapter 2 Product Overview
78-15136-03