Connecting Stackwise Cable To Stackwise Ports - Cisco ME-C3750-24TE-M Hardware Installation Manual

Chapter 3 Switch Installation

Connecting StackWise Cable to StackWise Ports

Step 1
Step 2
Step 3
Step 4
78-15136-02
To use the CLI, enter commands at the Switch> prompt through the console port
by using a terminal program or through the network by using Telnet. For
configuration information, refer to the switch software configuration guide or the
switch command reference. To use CMS, go to the
Page" section on page
Follow these steps to connect the StackWise cable to the StackWise ports:
Remove the dust covers from the StackWise cables and StackWise ports, and
store them for future use.
Insert one end of the StackWise cable into the StackWise port on the back of the
switch.
Always use a Cisco-approved StackWise cable to connect the switches.
Note
Use the window in the StackWise cable to align the connector correctly. Secure
the screws tightly.
Insert the other end of the cable into the connector of the other switch, and secure
the screws tightly.
Removing and installing the StackWise cable can shorten its useful
Caution
life. Do not remove and insert the cable more often than is absolutely
necessary.
When the connectors are not being used, replace the dust covers on them
Note
to protect them from dust.
Connecting StackWise Cable to StackWise Ports
C-3.
Catalyst 3750 Switch Hardware Installation Guide
"Launching the Switch Home
3-37