Cisco Catalyst 3750 Hardware Installation Manual page 57

Chapter 2 Product Overview
100BASE-TX and 1000BASE-T traffic requires Category 5 cable. 10BASE-T
Note
traffic can use Category 3 or Category 4 cables.
When connecting the switch to workstations, servers, routers, and Cisco IP
Phones, be sure that the cable is a straight-through cable. When connecting the
switch to switches or hubs, use a crossover cable. When using a straight-through
or crossover cable for 1000BASE-T connections, be sure to use a twisted
four-pair, Category 5 cable for proper operation. Pinouts for the cables are
described in
You can use the mdix auto interface configuration command in the CLI to enable
Note
the automatic medium-dependent interface crossover (Auto-MDIX) feature.
When the Auto-MDIX feature is enabled, the switch detects the required cable
type for copper Ethernet connections and configures the interfaces accordingly.
Therefore, you can use either a crossover or a straight-through cable for
connections to a copper 10/100, 10/100/1000, or 1000BASE-T SFP module port
on the switch, regardless of the type of device on the other end of the connection.
The Auto-MDIX feature is enabled by default on switches running Cisco IOS
Release 12.2(18)SE or later. For releases between Cisco IOS
Release 12.1(14)EA1 and 12.2(18)SE, the Auto-MDIX feature is disabled by
default. For configuration information for this feature, refer to the switch software
configuration guide or the switch command reference.
78-15136-03
Appendix B, "Connector and Cable Specifications."
Catalyst 3750 Switch Hardware Installation Guide
Front Panel Description
2-9