Setup
This chapter identifies the hardware and software requirements, and the preliminary setup
procedures required prior to bringing up the targeted reference design.
Requirements
Hardware
Board and Peripherals
•
KCU105 board with the Kintex® UltraScale™ XCKU040-2FFVA1156E FPGA
•
USB cable, standard-A plug to micro-B plug (Digilent cable)
•
Power supply: 100 VAC–240 VAC input, 12 VDC 5.0A output
•
ATX power supply
•
ATX power supply adapter
Computers
A control computer is required to run the Vivado® Design Suite and confige the on-board
FPGA. It can be a laptop or desktop computer with any operating system supported by
Vivado tools, such as Redhat Linux or Microsoft® Windows 7.
The reference design test configuration requires a host computer comprised of the chassis,
containing a motherboard with a PCI Express slot, monitor, keyboard, and mouse. A DVD
drive is also required if a Linux operating system is used. If a Windows 7 operating system
is used, the 64-bit Windows 7 OS and the Java SE Development Kit 7 must be installed.
Software
Vivado Design Suite 2017.2 is required. The Fedora 20 LiveDVD, on which the TRD software
and GUI run, is only required if a Linux operating system is used.
PCI Express Control Plane TRD
UG918 (v2017.2) July 18, 2017
www.xilinx.com
Chapter 2
8
Send Feedback