Run The Design On The Host Computer - Xilinx KCU105 User Manual

Run the Design on the Host Computer

This section provides instructions to run the reference design on either a host computer
with Linux, or a host computer with Windows 7.
Run the Design on a Linux Host Computer
Setup
This section describes how to set up the reference design using the Linux drivers and the
Fedora 20 LiveDVD.
Figure 3-7 shows different boot stages of Fedora 20. After you reach the third screen,
shown in Figure
you run the Fedora operating system from the DVD.
If you want to install Fedora 20 on the hard drive connected to the host system, click the
CAUTION!
Install to Hard Drive option. BE CAREFUL! This option erases any files on the hard disk!
X-Ref Target - Figure 3-7
Check for PCIe Devices
1. After the Fedora 20 OS boots, open a terminal and use lspci to see a list of PCIe devices
detected by the host:
$ lspci | grep -i xilinx
The following is displayed:
03:00.0 Memory controller: Xilinx Corporation Device 8011
If the host computer does not detect the Xilinx PCIe Endpoint,
Note:
Xilinx device.
PCI Express Control Plane TRD
UG918 (v2017.2) July 18, 2017
3-7, click the Try Fedora option, then click Close. It is recommended that
Figure 3-7: Fedora 20 Boot Stages
www.xilinx.com
Chapter 3: Bringing Up the Design
UG918_c3_09_011415
does not show a
lspci
Send Feedback
21