Xilinx KCU105 User Manual page 22

Run the Design
1. Navigate to the <working_dir>/kcu105_control_plane/software folder and
open a terminal. (The TRD files were extracted to your <working_dir> in
the Targeted Reference Design Files, page
2. Enter:
$ cd <working_dir>/kcu105_control_plane
$ sudo chmod +x quickstart.sh
$ sudo sh quickstart.sh
3. The TRD setup screen is displayed
with an ID of 8011, a control plane design selection, and a control plane driver mode.
Click Install and the drivers are installed. This takes you to the Control and Monitoring
GUI as shown in
X-Ref Target - Figure 3-8
PCI Express Control Plane TRD
UG918 (v2017.2) July 18, 2017
(Figure
Figure 3-12, page 26.
Figure 3-8: TRD Setup Screen with a PCIe Device Detected
www.xilinx.com
Chapter 3:
9).
3-8) and indicates detection of a PCIe device
Bringing Up the Design
Download
UG918_c3_10_021815
22
Send Feedback