Xilinx KCU105 User Manual page 33

Simulation setup is provided only for the base design and not for the pre-built user
extension design.
Running Simulation Using the Vivado Simulator
1. Open a terminal window on a Linux system with the Vivado environment set up, or open
a Vivado tools Tcl shell on a Windows system.
2. Navigate to the kcu105_control_plane/hardware/vivado/scripts/base
folder.
3. To run simulation, enter:
$ vivado -source trd01_base.tcl
This opens the Vivado IDE with the target simulator set to the Vivado Simulator
(Figure 4-5).
X-Ref Target - Figure 4-5
PCI Express Control Plane TRD
UG918 (v2017.2) July 18, 2017
Figure 4-5: Base Design Project Settings for Simulation
www.xilinx.com
Chapter 4: Implementing and Simulating the Design
UG918_c4_05_070717
33
Send Feedback