Video Demo Hardware Requirements; Video Demo Hardware Setup Instructions - Xilinx Virtex-6 FPGA ML605 Embedded Kit Getting Started

X-Ref Target - Figure 1
EEPROM
Note:
Processor Subsystem Hardware

Video Demo Hardware Requirements

In addition to the equipment supplied with the Embedded Kit, you will also need the
following to run the Video Demo:
•
•

Video Demo Hardware Setup Instructions

1.
Note:
not connect to your regular LAN network using DHCP. Do not connect more than one board to the
same network segment.
ML605 Getting Started Guide
UG730 (v1.1) June 14, 2010
Memory
FLASH/SRAM
FLASH
Controller
(32 MB)
SysACE
Compact
CompactFlash
FLASH
Controller
IIC EEPROM
Controller
Multiport
DDR3
Memory
(512 MB)
Controller
XIL_VFBC
Display
Controller
Display_Cntlr_
DVI_VIDEO_OUT
Figure 1: Virtex-6 FPGA Video Demo System
Instructions on building the Video Demo system are detailed in
DVI cable and DVI Monitor
or
DVI to VGA adapter, VGA Cable, and VGA Monitor
Connect the Ethernet Cable directly to a PC. Set the IP address of the PC to
192.168.1.100. You will need to return the IP address of the PC back to its original
setting after running the demo.
The demo uses a hard coded MAC address and a fixed IP address of 192.168.1.10 and will
www.xilinx.com
MicroBlaze Processor Subsystem
Processor Block
Internal RAM
(8 KB)
MicroBlaze
8 KB I and D Caches
Dual
Timer/Counter
Internal
Interrupt
RAM
Controller
(64 KB)
3 x 3 FIR
Filter
FIR_3x3_DVI_
VIDEO_OUT
Configurable User Logic
Tutorial.
Introduction
Input/Output
LEDs
GPIO
GPIO Positional LEDs
GPIO Buttons
GPIO Switches
RS232
UART
Line Driver/
16550
Receiver
TriMode
Ethernet
Ethernet
PHY
MAC
dvi_out_de
dvi_out_vsync
dvi_out_hsync
DVI
dvi_out_data
DVI
dvi_out_clk_n
Controller
cvi_out_clk_n
video_out_scl
XPS
video_out_sda
IIC
dvi_rest_n
XC6VLX240T
UG730_01_051210
UG731 ML605 MicroBlaze
11