Configure The Fpga - Xilinx KCU105 User Manual

Configure the FPGA

While in BIOS, program the FPGA with the BIT file:
1. Connect the standard-A plug to micro-B plug USB cable to the JTAG port on the KCU105
board and to the control computer laptop as shown in
The host system can remain powered on.
Note:
X-Ref Target - Figure 3-1
Figure 3-1: Connect the USB Cable to the KCU105 Board and Control Computer
Figure 3-1
Note:
production boards.
PCI Express Control Plane TRD
UG918 (v2017.2) July 18, 2017
shows a Rev C board. The USB JTAG connector is on the PCIe panel for
www.xilinx.com
Chapter 3: Bringing Up the Design
Figure 3-1.
UG918_c3_03_042115
Send Feedback
15