Install Drivers - Xilinx KCU105 User Manual

Install Drivers

1. From the Windows explorer, navigate to the folder in which the reference design is
downloaded (<dir>\kcu105_control_plane\software\windows\) and run the
setup file with Administrator privileges, as shown in
X-Ref Target - Figure 2-2
2. Click Next after the InstallShield Wizard opens.
3. Click Next to install to the default folder; or click Change to install to a different folder.
4. Click Install to begin driver installation.
5. A warning screen displays as the drivers are installed, because the drivers are not signed
by a trusted certificate authority yet. To install the drivers, ignore the warning message
and click Install this driver software anyway. This warning message pops up two
times. Repeat this step.
6. After installation is complete, click Finish to exit the InstallShield Wizard.
Set DIP Switches
Ensure that the DIP switches and jumpers on the KCU105 board are set to the factory
default settings as identified in the Kintex UltraScale FPGA KCU105 Evaluation Board User
Guide (UG917)
PCI Express Control Plane TRD
UG918 (v2017.2) July 18, 2017
Figure 2-2: Run the Setup File with Administrator Privileges
[Ref 3].
www.xilinx.com
Chapter 2: Setup
Figure 2-2.
UG918_c2_02_040715
Send Feedback
11