Control Terminal Strip X2A - KEB COMBIVERT G6 series Installation Manual

4.1.4

Control terminal strip X2A

The control terminal strip is designed as a double, plug-in terminal strip with spring cage con-
nection. It contains 32 pole. The following instructions must be observed at connection:
Attention
4.1.4.1 Assembly of the wires
Required tools:
Screw driver SD 0,4 x 2.5 (DIN 5264)
1. Strip cable
Cable
rigidly and flexibly
2. Plug screw driver mid into the square slot
3. Plug cable into the round slot, that no wires can be seen
from the outside.
4. Remove screw driver and check if cables are fixed.
Prevent EMC malfunctions
• Use shielded / drilled cables
• Lay shield on one side of the inverter onto earth potential
• Lay control and power cable separately (about 10...20 cm apart); Lay
crossings in a right angle (in case it cannot be prevented)
permissible cross-section
0.08...1 mm2 (AWG22...18)
Control
GB - 25