KEB COMBIVERT G6 series Installation Manual page 35

5 DC link voltage CP.07
6 apparent current CP.04
7 active current ru.17
8...10 reserved
11 absolute active current ru.17
12 power stage temperature ru.38
13...21 reserved
22 Analog input before amplification (ru.27)
23 Analog input after amplification (ru.28)
24...25 reserved
26 Active power ru.81
CP.32 Transistor output / function (term. X2A.10)
The switching level of CP.32 is pre-set to 4.00. Value range see CP.33.
CP.33 Relay output 1 / function (terminals X2A.11...13)
The switching level of CP.33 is adjusted by CP.34.
Value Function
0 No function (generally off)
1 Generally on
2 Run signal; also by DC-braking
3 Ready signal (no error)
4 Fault relay
5 Fault relay (without auto-reset)
6 Warning or error message (also at fast stop)
7 Overload pre-warning (OL)
8 Overtemperature pre-warning (OH)
9 External Overtemperature pre-warning (dOH)
10 Motor protection pre-warning (OH2)
11 Interior temperature pre-warning (OHI)
12 Cable breakage 4...20 mA on analog input 1
14 max. constant current (Stall, CP.25) exceeded
15 max. ramp current (LA-Stop, CP.24) exceeded
16 DC-braking active
20 Actual value = set value (CP.3 = Fcon; rcon; not at noP, LS, error, SSF)
21 Accelerate (CP.3=FAcc, rAcc, LAS)
22 Decelerate (CP.3 = FdEc, rdEc, LdS)
23 Real direction of rotation = set direction of rotation
24 Utilization (CP.6) > switching level
25 Active current > switching level
26 Intermediate circuit voltage (CP.7) > switching level
27 Real value (CP.1) > switching level
28 Set value (CP.2) > switching level
31 Absolute set value at AN1 > switching level
34 Set value at AN1 > switching level
40 Hardware current limit activated
41 modulation on
44 Inverter status > switching level
47 Ramp output value > switching level
48 Apparent current (CP.4) > switching level
49 Forward running (not at nOP, LS, abnormal stopping or error)
50 Reverse running (not at nOP, LS, abnormal stopping or error)
63 Absolute ANOUT1 > switching level
65 ANOUT1 > switching level
70 Driver voltage active (safety relay)
73 Absolute active power > switching level
74 Active power > switching level
Parameter Description
0...1000 V
0...2 • rated current
0...2 • ±rated current
0...2 • rated current
0...100 °C
0...100 %
0...400 %
0...±2 • Rated power
further on next side
GB - 35
–
–
–