Right Handlebar Switches; Stop Position; Run Position; Start Position - Triumph Bonneville Bobber Owner's Handbook Manual

General Information

Right Handlebar Switches

1
6
1. Engine start/stop switch
2.

STOP position

3.

RUN position

4.

START position

5.

MODE button

6. Hazard warning light switch
STOP Position
The STOP position is for emergency use.
If an emergency arises which requires
the engine to be stopped, move the
engine start/stop switch to the STOP
position.
Do not leave the ignition switch in
the ON position unless the engine is
running as this may cause damage
to electrical components and will
discharge the battery.
44
2
3
4
5
Caution
Note
Although the engine stop switch stops
the engine, it does not turn off all
the electrical circuits and may cause
difficulty in restarting the engine due
to a discharged battery. Ordinarily, only
the ignition switch should be used to
stop the engine.
RUN Position
In addition to the ignition switch being
turned to the ON position, the engine
start/stop switch must be in the RUN
position for the motorcycle to operate.
START Position
The START position operates the electric
starter. For the starter to operate,
the clutch lever must be pulled to the
handlebar.
Note
Even if the clutch lever is pulled to the
handlebar, the starter will not operate
if the side stand is down and a gear is
engaged.
MODE Button
The MODE button
response adjustment. Press and release
the MODE button to select one of the
different rider modes available (see
page 34 for more information).

Hazard Warning Lights Switch

To turn the hazard warning lights on
or off, push the hazard warning light
switch to the left or right.
The ignition must be switched ON for
the hazard warning lights to function.
allows throttle