Traction Control (Tc) Disabled Warning Light; Turn Signal Light; Hazard Warning Lights; High Beam Indicator Light - Triumph Speed 400 Owner's Handbook Manual

INSTRUMENTS
30
Traction Control (TC) Disabled
Warning Light
The
disabled warning light should
not illuminate unless traction
control is switched off or
there is a malfunction.
If the warning
illuminated while riding, it indicates
that the traction control system has a
malfunction that requires investigation.
The fault
rectified by a competent person with
the specialist knowledge and technical
understanding of motorcycles, such as
an authorized Triumph dealer.

Turn signal Light

When the turn signal switch is
turned to the left or right, the
turn signal light will flash on
and off at the same speed as
the turn signals.

Hazard Warning Lights

When the hazard warning
switch is turned on, the turn
signal warning lights will flash
on and off at the same speed
as the turn signals.

High Beam Indicator Light

When the ignition is switched
ON and the high beam is
selected,
indicator light will illuminate.
Traction Control
light becomes
must be checked
the high
Daytime Running Lights (DRL)
Indicator Light (if equipped)
(TC)
running
illuminate. During daylight hours, the
Daytime Running Lights (DRL) improve
the visibility of the motorcycle to other
road users. Dipped beam headlights
must be used in any other conditions
and
unless the road conditions allow for high
beam headlights to be used.
When the dipped beam headlight is
switched on, the daytime running lights
indicator light will be off.
The daytime running lights and dipped
beam headlights are operated manually
using a switch on the left hand switch
housing.
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the Daytime Running
Lights when dark, in tunnels or where
poor ambient light is apparent may
reduce the riders vision or blind other
road users.
Blinding other road users or reduced
vision in low ambient light levels may
lead to loss of motorcycle control
beam
which could result in serious injury or
death.
When the ignition is switched
ON and the daytime running
lights switch is set to Daytime
Running Lights, the daytime
lights indicator
WARNING
light will