Initialize System (Init-Sys); Init-Sys Keywords - Symmetricom TimeProvider 1100 Reference Manual

Initialize System (INIT-SYS)

This command initializes the specified module, or the system.
Caution:
IOC to enter the Warm-up mode; the outputs are squelched until the
system enters FAST-LOCK.
After issuing the INIT-SYS command with the SYS aid and FACTORY
keyword, all system parameters are reset, including the entire user
list. You must therefore create a new security-level user after the user
list is reset to avoid a service call. Refer to "Defining the First User" in
the TimeProvider User Guide (097-58001-02) for more information.
This command has a default access level of ADMIN.
Syntax
INIT-SYS:[<tid>]:<aid>:[<ctag>]::<keyword>;
Parameter
<aid>
Table 2-8. INIT-SYS Keywords
<keyword>
FACTORY Resets system settings to factory default values.
RESET Performs a reset (reboot) of the specified card, which reinitializes
volatile memory, but does not affect non-volatile (persistent)
memory.
Note: Prior to resetting an IOC module, all alarms associated with
the module are cleared, and if the specified IOC module is the
active module, it is placed in Standby mode. Resetting an IOC in a
non-redundant system will squelch the outputs until the system
enters FAST-LOCK.
097-58001-01 Revision E – September 2006
This command causes the local oscillator in the specified
Value
SYS The command's effect is at the system level.
Note: See
IMC The command's effect is on the IMC module.
Note: See
IOCm The command's effect is on the Input/Output Card module
specified by m:
m = "1" for the slot marked "IOC 1" on the main shelf
m = "2" for the slot marked "IOC 2" on the main shelf
Note: See
Description
<aid> = SYS
<aid> = IMC | IOCm
Chapter 2 TL1 Command Syntax and Description
Description
Table 2-8 for the <keyword> description.
Table 2-8 for the <keyword> description.
Table 2-8 for the <keyword> description.
TimeProvider TL1 Reference Guide
Initialize System (INIT-SYS)
Default
N/A
N/A
67