Ed-Eqpt For Ntp Parameters - Symmetricom TimeProvider 1100 Reference Manual

ED-EQPT for NTP Parameters

There are two sets of ED-EQPT commands to set up the NTP option on the
TimeProvider:
Peer Server
Authentication
These commands have a default access level of ADMIN.
Configuring the Peer Server
When you set the <func> value to ADD or MODIFY, you must include the <keyid>,
<minpoll>, <maxpoll> and <preferred> values.
Syntax
ED-EQPT:[<tid>]:NTP:[<ctag>]::SERVER,<func>,<serverIP>[,<keyid>,
<minpoll>,<maxpoll>,<preferred>];
<keyword>
FUNC ADD | DELETE |
MODIFY
SERVERIP 1.0.0.1 –
254.255. 255.254
KEYID 1 to 65534
MINPOLL 16 | 32 | 64 | 128 |
256 | 512 | 1024
MAXPOLL 16 | 32 | 64 | 128 |
256 | 512 | 1024
PREFERRED YES | NO
Example
This command adds the server mask of 192.168.10.1, sets the Authentication ID to
1, the max poll to 64, the min poll to 1024, and the preferred to No.
Input
ED-EQPT::NTP:TP1000::SERVER,ADD,192.168.10.1,1,64,1024,NO;
097-58001-01 Revision E – September 2006
<value>
The SERVERIP address to be added, deleted,
or modified.
The NTP IP Mask
Note: If you change this parameter while NTP
is functioning, you must restart the IMC card
(using the INIT-SYS command) to use the new
address.
The Authentication identification value
The minimum amount of time, in seconds,
between Server time requests.
The maximum amount of time, in seconds,
between Server time requests.
Sets the server to be the Preferred server.
Chapter 2 TL1 Command Syntax and Description
ED-EQPT for NTP Parameters
Description
TimeProvider TL1 Reference Guide
Default
NA
0.0.0.0
0
16
1024
NO
51