Symmetricom TimeProvider 1100 Reference Manual page 158

Appendix C Events
Table C-1. Event Identifiers (Continued)
Event ID
or Event Description
CONDTYPE
FLOW The IMC serial port flow
control has changed
FWFAIL The firmware upgrade of
IMC was unsuccessful.
The firmware upgrade of
the IOC was unsuccessful.
FWOK The firmware upgrade of
IMC was successful. The
firmware upgrade of the
IOC was successful.
IMCBIST The user has requested
the IMC to perform a
Built-in Self Test.
INACTTIME Set the communication
inactivity timeout. If no
user command is entered
within the specified time
the user's session is
terminated.
INITLOG The event log has
initialized.
IPADDR The IMC Ethernet
address has changed.
IPGATE The IMC Ethernet gateway
address has changed.
IPSUB The IMC Ethernet subnet
mask has changed.
ISDIFF Indicates that the CRC of
two Istates images stored
on separate modules are
different.
ISEQ Indicates that the CRC of
two Istate images stored
on separate modules are
equal.
158 TimeProvider TL1 Reference Guide
AID
Default Value
TYPE
EQPT NONE
EQPT NA
EQPT NA
EQPT NA
EQPT 0 (no timeout)
EQPT NA
EQPT 0.0.0.0
EQPT 0.0.0.0
EQPT 255.255.255.0
EQPT NA
EQPT NA
Value Description
NONE – No flow control
SW – Software flow control
XON/XOFF
HW – Hardware flow control
CTS/RTS
SWHW – Use both types of
flow control
NA
NA
PASSED – test(s) passed
FAILED – test(s) failed
0 = Disable timeout
100 to 10000 (seconds)
NA
1.0.0.1 to 254.255.255.254
1.0.0.1 to 254.255.255.254
1.0.0.1 to 254.255.255.254
NA
NA
097-58001-01 Revision E – September 2006