Activate User (Act-User) - Symmetricom TimeProvider 1100 Reference Manual

Chapter 2 TL1 Command Syntax and Description

Activate User (ACT-USER)

Activate User (ACT-USER)
This command logs the specified existing user onto the system, and begins a user
session. Each session is independent, allowing a user to have multiple sessions
with no interaction among sessions (requested data is delivered to the proper
session). If a user has a current session active, that user can log in using another
user name, which transfers the current session to the new user name. The system
records the log-in event, but does not record a log-out event for the previous user. If
no users are defined in the system, then the user has access at the Security level.
This command has a default access level of NONE. This command's access level
cannot be changed.
Syntax
ACT-USER:[<tid>]:<uid>:[<ctag>]::<pid>;
Parameter
<uid>
<pid>
The maximum number of sessions is ten.
Note: A Security-level user initially sets up the user list by using the
Enter User Security (ENT-USER-SECU)
using the ACT-USER command, specifying the user name and
password that have been assigned by a Security-level user.
Example
To log user "FRED" into the TimeProvider system with the password "FRED.1":
Input
ACT-USER::FRED:TP1000::FRED.1;
Normal Response
TP-SSU
M TP1000 COMPLD
;
Autonomous Message
TP-SSU 05-02-10,13:35:56
A 2528 REPT EVT
"IMC,EQPT:LOGIN,TC,05-02-10,13-35-56,,,,:\"USER LOGGED IN, FRED\""
;
34 TimeProvider TL1 Reference Guide
Value
text string The user name assigned to the user logging on.
text string The password assigned to the user logging on.
Note: Refer to <newpid>, on page 63 for valid password
specifications.
05-02-10 13:35:56
Description
command. Users log in
097-58001-01 Revision E – September 2006