Analog Input As Setpoint Source - Siemens SINAMICS G120C USS/MB Operating Instructions Manual

Advanced commissioning
6.16 Setpoints
6.16.2

Analog input as setpoint source

Interconnecting an analog input
If you have selected a pre-assignment without a function of the analog input, then you must
interconnect the parameter of the main setpoint with an analog input.
Figure 6-32
Table 6-33
Parameter
p1070 = 755[0]
p1075 = 755[0]
236
Example: Analog input 0 as setpoint source
Setting with analog input 0 as setpoint source
Remark
Main setpoint
Interconnect the main setpoint with analog input 0
Additional setpoint
Interconnect the additional setpoint with analog input 0
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34263257B AF
SINAMICS G120C converter