Controller Enclosure Installation (For Regions Other Than The Emeia, Central American, And Caribbean Regions) - Fujitsu ETERNUS AF250 S2 Configuration Manual

Chapter 2 Rack Installation
2.2

Controller Enclosure Installation (for Regions other than the EMEIA, Central American, and Caribbean Regions)

2.2 Controller Enclosure Installation (for Regions other than the
EMEIA, Central American, and Caribbean Regions)
This section describes how to install the controller enclosure in a rack.
1
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the front and
rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be attached to the rack
before they can be completely tightened.
Loosen the M4 screws to
adjust the length of the
rack rails to match the
distance between the
front and rear rack pillars.
[Left]
2
Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the washers to fasten the rack
rails to the rear rack pillars.
Rack rail (left)
An "L" mark is on the
inner side.
(Rack pillar: front)
[Right]
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
(Rack pillar: rear)
Rack rail (right)
An "R" mark is on the inner side.
28
P3AG-1832-04ENZ0