Fujitsu ETERNUS AF250 S2 Configuration Manual page 68

Chapter 5 General Settings
5.4 Storage Management (Initial Setup 1)
(2)
Click the [OK] button.
The SED authentication key is registered and the registration completion screen appears.
(3)
Click the [Done] button.
The [Setup Network Environment] screen appears.
•
•
7
Network environment setup
Set the ETERNUS AF environment for network communication.
If the network environment is set with the factory default, some functions are not available.
Make sure to set up the network environment.
• Do not use the RMT port for an operation management LAN. Use the RMT port only for remote sup-
port.
• Configure the IP address for the MNT port with an IP address in a different subnetwork than the
RMT port.
When specifying the IP address of the Slave CM, specify an IP address that is in the same subnet
•
but is different from the IP address of the Master CM.
Either or both an IPv4 address and an IPv6 address can be specified for the MNT port and the RMT
•
port.
• To connect to the devices in a network in which the ETERNUS AF does not belong, set "Gateway",
and specify the IP address (or network address) or the connect IP address in "Allowed IP Address".
If the ETERNUS AF is accessed from a system with the same network address (or same subnet-
work), the IP address does not need to be set.
The SED authentication key can be registered even if no SEDs are or will be installed.
When SEDs are already installed in the ETERNUS AF, a message that requests rebooting ap-
pears. Reboot the ETERNUS AF according to the displayed message.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
68
P3AG-1832-04ENZ0