Fujitsu ETERNUS AF250 S2 Configuration Manual page 106

Chapter 7 Power Control Setup
7.1 Setup of the Auto Power Function and/or the Power Resume Function
The procedure to enable the Auto Power function and the Power Resume function is described below.
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [System Settings].
The [System Settings] screen appears.
3
In [Action], click [Setup Power Management].
The [Setup Power Management] screen appears.
4
In the [Setup Power Management] screen, select [Enable] for [Auto Power], [Power Resume], or both.
5
Click the [Set] button.
A confirmation screen appears.
6
Click the [OK] button.
The Auto Power function and/or the Power Resume function setting is applied.
7
Check the setting completion message and click the [Done] button.
The screen display returns to the [System Settings] screen.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
106
P3AG-1832-04ENZ0