Fujitsu ETERNUS AF250 S2 Configuration Manual page 43

Chapter 3 Checking the Configuration Environment
3.4 LAN Connection Preparation for Operation Management
Usage
REMCS
(remote support)
AIS Connect (remote
support)
Syslog
(event notification
and audit log send-
ing)
RADIUS
ping
KMIP (key manage-
ment)
ETERNUS DX Discov-
ery
¡: Possible / △: Partially possible / ´: Not possible
*1: Only the following functions are available:
Checking the ETERNUS AF status
•
Switching the Master CM
•
*2: May use either the MNT port or RMT port.
*3: Modifiable
For details on the port numbers for the ETERNUS SF Software, refer to the manual of each Storage Foundation
Software ETERNUS SF.
■
Communication Modes
The default LAN operation mode is "Auto Negotiation" which allows the ETERNUS AF to automatically recog-
nize 1000BASE-T/100BASE-TX/10BASE-T and Full/Half-Duplex connections. However, some devices may re-
quire that a fixed communication mode be set.
Port
Protocol tcp / udp
number
smtp tcp Must be
set
http (cli- tcp Must be
ent) set
https (cli- tcp 443
ent)
Syslog udp Must be
set
Radius udp Must be
set
ICMP − −
SSL tcp 5696
(*3)
Unique udp 9686
protocol
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
Master CM
Direction
MNT RMT
to ¡ (*2) ¡ (*2)
to ¡ (*2) ¡ (*2)
to ¡ (*2) ¡ (*2)
to
¡ (*2) ¡ (*2)
to ¡ (*2) ¡ (*2)
from ¡ (*2) ¡ (*2)
to ¡ (*2) ¡ (*2)
´
from ¡
43
Slave CM
Remarks
MNT RMT
´ ´
Used for
failure
notifica-
tion, etc.
´ ´
Used for
firmware
down-
load, etc.
´ ´
—
´ ´ −
´ ´
−
´ ´
−
´ ´
−
´ ´
−
P3AG-1832-04ENZ0