Preparing The Pc Terminal For Setup - Fujitsu ETERNUS AF250 S2 Configuration Manual

Chapter 3 Checking the Configuration Environment
3.3

Preparing the PC Terminal for Setup

6
Shut down the server.
After this, the settings for the ETERNUS AF must be completed before connecting the ETERNUS AF to
the server. In order to perform these settings, turn off the server.
3.3 Preparing the PC Terminal for Setup
The initial settings are performed by using a Web browser on the PC terminal.
Prepare and set up the PC terminal before the initial settings.
Preparing the PC terminal
Prepare the PC terminal that contains the following environment:
Web browser
•
Usable Web browsers are shown below. Using Web browsers other than the following is possible, but prop-
er operation is not guaranteed.
Microsoft Internet Explorer 7.0, 8.0, 9.0, 10.0 (desktop version), 11.0 (desktop version)
-
- Mozilla Firefox 3.6.x, ESR 10.0.x, ESR 17.0.x, ESR 24.0.x
Setting up the PC terminal
Set up the PC terminal with the following procedure:
1
Set the IP address and subnet mask of the PC terminal.
Set the following values.
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
2
Check the settings of the Web browser.
For details on the required settings, refer to "Configuration Guide (Web GUI)".
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
40
P3AG-1832-04ENZ0