Fujitsu ETERNUS AF250 S2 Configuration Manual page 25

Chapter 2 Rack Installation
2.1 Power Distribution Unit Installation (for Regions other than the EMEIA, Central American, and Caribbean Regions)
3
Install the power distribution unit in the rack.
Fasten the power distribution unit to the bracket with the two M3 screws removed in
M3 screw
(Rack pillar: rear)
4
Attach the blank panel to the front side of the rack.
The blank panel should be attached at the same height as the power distribution unit.
Power distribution unit
(Rack pillar: rear)
M3 screw
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
Blank panel
(Rack pillar: front)
25
Step 1.
P3AG-1832-04ENZ0