Installing The Access Point; Guidelines For Installing The At-Mws600Ap Or At-Mws1750Ap Access Point - Allied Telesis AT-MWS600AP Installation Manual

Chapter 3: Installing the AT-MWS600AP or AT-MWS1750AP Access Point

Installing the Access Point

Guidelines for
Installing the
AT-MWS600AP
or
AT-MWS1750AP
Access Point
46
The AT-MWS600AP and AT-MWS1750AP access points can be mounted
on a table, wall, hard-surface celling, or ceiling rail.
Review the following guidelines before installing the access point:
The ceiling or wall mounting surface must be of proper material to

accommodate the screws, strong enough to support the weight of
the access point and cables.
The ceiling rail must be strong enough to support the weight of the

access point and cables.
Ensure the cables are long enough to connect to the places you

planned before installing the access point. Once the access point
is installed, it may be difficult to change the cables.
Connect the Ethernet cable and power code to the access point

before installing the access point on the ceiling or wall. Connecting
the Ethernet cable and power code may be difficult after the
access point is installed.
The access points can be installed on a table and ceiling. See

Figure 18 for correct orientations.
Figure 18. Correct Orientation on a Tabletop and Ceiling
The access point must be mounted on the wall in the orientations

shown in Figure 19. In other orientations, the access point cannot
have a proper air flow.
Figure 19. Correct Orientations on a Wall
The access point can be attached to installed on two types of

suspended ceiling T-rails. Select one of the ceiling grip clips in the
shipping box for your ceiling rail.