Allied Telesis AT-MWS600AP Installation Manual page 49

Note
Ensure the cable is long enough to connect the access point to the
place where you planned. Once the access point is installed, it may
be difficult to change the cable.
7. If you plan to use the AC adapter, connect it. See "Connecting the AC
Adapter" on page 54.
Note
Ensure the power outlet is in the reach. Once the access point is
installed, it may be difficult to change the location.
8. If you are installing the access point on the wall, ensure that the
orientation of the mounting base is correct.
9. Using the mounting base as a template, mark the two holes with a
pencil where you want to install the access point. See Figure 23.
Figure 23. Marking the Mounting Base Holes
10. Pre-drill the marked locations on the hard-surface ceiling or wall.
11. Install the mounting base on the hard-surface ceiling or wall as shown
in Figure 24.
Figure 24. Installing the Mounting Base on a Hard-Surface Ceiling or Wall
MWS Series Access Point Installation Guide
49