Unpacking The At-Mws600Ap Or At-Mws1750Ap Access Point - Allied Telesis AT-MWS600AP Installation Manual

Chapter 3: Installing the AT-MWS600AP or AT-MWS1750AP Access Point

Unpacking the AT-MWS600AP or AT-MWS1750AP Access Point

Mounting
base kit
44
To unpack the AT-MWS600AP or AT-MWS1750AP access point, perform
the following procedure:
1. Remove all components from the shipping boxes.
Note
Store the packaging material in a safe location. You must use the
original shipping material if you need to return the unit to Allied
Telesis.
2. Verify that all components listed in Table 7 are included in your
shipping boxes.
Table 7. Components in the Shipping Boxes
Name
1 x Mounting base
2 x Screw for the
mounting base
(M2.6 9.8mm)
Component