What To Prepare For The Installation; Installing The Access Point On The Celling Or Wall - Allied Telesis AT-MWS600AP Installation Manual

What to Prepare
for the
Installation
Installing the
Access Point on
the Celling or
Wall
You need the following items to install the access point on a ceiling or wall:
AT-MWS2533AP access point

AT-BRKT-MWS01 Mounting base plate

Four screws for a celling or wall

Phillips-head screwdriver

Pencil

Note
Screws for the ceiling or wall, a Phillip-head screwdriver and pencil
are not included in the shipping box.
To install the access point on the celling or wall, perform the following
procedure:
Note
Attaching the access point to the mounting base plate may not be
easy once the mounting base plate is installed on a ceiling or wall.
Practice Step 5 to Step 7 before installing the mounting base plate
on a ceiling or wall.
1. Review "Guidelines for Installing the Device on a Celling or Wall" on
page 34.
2. Using the mounting base plate as a template, mark the four holes with
a pencil.
3. Pre-drill the marked locations on the ceiling or wall.
4. Install the mounting base plate on the ceiling or wall as shown in
Figure 9 on page 36.
MWS Series Access Point Installation Guide
35