Allied Telesis AT-MWS600AP Installation Manual page 48

Chapter 3: Installing the AT-MWS600AP or AT-MWS1750AP Access Point
48
3. Attach the two screws to the access point. as shown in Figure 20.
Figure 20. Attaching the Screws to the Access Point
4. Apply the mounting base to the access point and adjust the height of
the screws where the access point can be turned to be secured to the
mounting base as shown in Figure 21.
Figure 21. Adjusting the Screws on the Access Point
5. Remove the mounting base from the access point. See Figure 22.
Figure 22. The Access Point with Two Screws Attached
6. Connect an Ethernet cable. See "Connecting the Access Point with the
Ethernet Cable" on page 53.