Xconfiguration Video Input Connector [2] Quality; Xconfiguration Video Input Connector [1..2] Visibility; Xconfiguration Video Monitors - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

xConfiguration Video Input Connector [2] Quality

When encoding and transmitting video there is a trade-off between high resolution and high
frame rate. For some video sources it is more important to transmit high frame rate than high
resolution and vice versa. This setting specifies whether to give priority to high frame rate or to
high resolution.
Requires user role: ADMIN, INTEGRATOR
Default value: Sharpness
USAGE:
xConfiguration Video Input Connector
where
n
: Unique ID that identifies the video input connector. Range: 2..2
Quality
: Motion/Sharpness
Motion: Gives the highest possible frame rate. Used when there is a need for higher
frame rates, typically when a large number of participants are present or when there is
a lot of motion in the picture.
Sharpness: Gives the highest possible resolution. Used when you want the highest
quality of detailed images and graphics.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
n Quality: Quality
xCommand

xConfiguration Video Input Connector [1..2] Visibility

Define the visibility of the video input connector in the menus on the user interface.
Note that Connector 1 is the system's integrated camera, which is not available as a presenta-
tion source.
Requires user role: ADMIN, INTEGRATOR
Default value: Connector 1: Never Connector 2: Always Connector 3: OnConnect
USAGE:
xConfiguration Video Input Connector
where
n
: Unique ID that identifies the video input connector. Range: 1..2
Visibility
: Connector 1: Never Connector 2, 3: Always/IfSignal/Never
Always: The menu selection for the video input connector will always be visible on the
user interface.
IfSignal: Yhe menu selection for the video input connector will only be visible when
something is connected to the video input.
Never: The input source is not expected to be used as a presentation source, and will
not show up on the user interface.

xConfiguration Video Monitors

Define the monitor layout mode. Note that this video system supports only one monitor, so this
value is fixed and cannot be changed.
Requires user role: ADMIN, INTEGRATOR
Default value: Single
USAGE:
xConfiguration Video Monitors:
where
Monitors
: Single
Single: The layout is shown on the video system's monitor.
86
API Reference Guide
xStatus Appendices
Visibility:
n Visibility
Monitors
Copyright © 2017 Cisco Systems, Inc. All rights reserved.