Xconfiguration Network [1] Ipstack; Xconfiguration Network [1] Ipv4 Assignment; Xconfiguration Network [1] Ipv4 Address; Xconfiguration Network [1] Ipv4 Gateway - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

xConfiguration Network [1] IPStack

Select if the system should use IPv4, IPv6, or dual IP stack, on the network interface. NOTE:
After changing this setting you may have to wait up to 30 seconds before it takes effect.
Requires user role: ADMIN, USER
Default value: Dual
USAGE:
xConfiguration Network n IPStack:
where
n
: Index that identifies the network. Range: 1..1
IPStack
: Dual/IPv4/IPv6
Dual: When set to Dual, the network interface can operate on both IP versions at the
same time, and can have both an IPv4 and an IPv6 address at the same time.
IPv4: When set to IPv4, the system will use IPv4 on the network interface.
IPv6: When set to IPv6, the system will use IPv6 on the network interface.

xConfiguration Network [1] IPv4 Assignment

Define how the system will obtain its IPv4 address, subnet mask and gateway address. This
setting applies only to systems on IPv4 networks.
Requires user role: ADMIN, USER
Default value: DHCP
USAGE:
xConfiguration Network n IPv4 Assignment:
where
n
: Index that identifies the network. Range: 1..1
Assignment
: Static/DHCP
Static: The addresses must be configured manually using the Network IPv4 Address,
Network IPv4 Gateway and Network IPv4 SubnetMask settings (static addresses).
DHCP: The system addresses are automatically assigned by the DHCP server.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
IPStack
Assignment
xCommand

xConfiguration Network [1] IPv4 Address

Define the static IPv4 network address for the system. Applicable only when Network IPv4
Assignment is set to Static.
Requires user role: ADMIN, USER
Default value: ""
USAGE:
xConfiguration Network n IPv4 Address: "Address"
where
n
: Index that identifies the network. Range: 1..1
Address
: String (0, 64)
A valid IPv4 address.

xConfiguration Network [1] IPv4 Gateway

Define the IPv4 network gateway address. Applicable only when the Network IPv4 Assignment
is set to Static.
Requires user role: ADMIN, USER
Default value: ""
USAGE:
xConfiguration Network n IPv4 Gateway: "Gateway"
where
n
: Index that identifies the network. Range: 1..1
Gateway
: String (0, 64)
A valid IPv4 address.
54
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.