Xcommand Call Hold; Xcommand Call Ignore; Xcommand Call Join; Xcommand Call Reject - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

xCommand Call Hold

Put a call on hold.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Hold [CallId: CallId] [Reason: Reason]
where
CallId
: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId. The default is set to 0.
Reason
: Conference/Transfer/Other
Internal usage only. The default is set to Other.

xCommand Call Ignore

Turns off the ringtone for the incoming call. The call can still be answered.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Ignore CallId: CallId
where
CallId
: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.

xCommand Call Join

Internal usage only.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Join CallId: CallId
where
CallId
: Integer (0..65534)
You can have from 1 to 10 CallId parameters in the same command.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xCommand xCommand

xCommand Call Reject

Reject incoming call. If no call id is specified, all incoming calls are rejected.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Reject [CallId: CallId]
where
CallId
: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId. The default is set to 0.

xCommand Call Resume

Resume a call that have been put on hold.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Resume [CallId: CallId]
where
CallId
: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId. The default is set to 0.

xCommand Call UnattendedTransfer

Transfers an ongoing call to another participant. Fully supported for SIP calls only.
Requires user role: ADMIN, USER
USAGE:
xCommand Call UnattendedTransfer CallId:
where
CallId
: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.
Number
: String (0, 255)
The number the call is transfered to.
102
API Reference Guide
xStatus Appendices
CallId Number: "Number"
Copyright © 2017 Cisco Systems, Inc. All rights reserved.