Xcommand Userinterface Presentation Externalsource State Set; Usermanagement Commands; Xcommand Usermanagement Remotesupportuser Create; Xcommand Usermanagement Remotesupportuser Delete - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

xCommand UserInterface Presentation ExternalSource State Set

Set or change the state of the input source (specified by the SourceIdentifier).
Requires user role: ADMIN, INTEGRATOR, ROOMCONTROL
USAGE:
xCommand UserInterface Presentation ExternalSource State Set SourceIdentifier:
"SourceIdentifier" State: State
where
SourceIdentifier
: String (0, 40)
The unique string that identifies this input source. It was defined when the source was
created with the UserInterface Presentation ExternalSource Add command.
State
: Hidden/Ready/NotReady/Error
Ready: The input source will be presented when someone selects it (taps it on the user
interface, or when the UserInterface Presentation ExternalSource Select command is
issued).
NotReady: The input source is not ready, and cannot be selected.
Error: The input source is in an erroneous state. The ErrorReason parameter may be
used to inform the user about the reason for failure.
Hidden: The input source will not be displayed in the user interface sharetray.
ErrorReason
: String (0, 80)
This string is displayed in the user interface sharetray, given that the State parameter is
set to Error.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration
[ErrorReason: "ErrorReason"]
xCommand xCommand

UserManagement commands

xCommand UserManagement RemoteSupportUser Create

Create a remote support user passphrase that Technical Assistance Center (TAC) can use to
access the system for troubleshooting.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Create [ExpiryDays: ExpiryDays]
where
ExpiryDays
: Integer (1..31)
Define the duration for the passphrase validity. Default is 7 days.

xCommand UserManagement RemoteSupportUser Delete

Delete the remote support user created with the command xCommand UserManagement
RemoteSupportUser Create.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Delete

xCommand UserManagement RemoteSupportUser DisablePermanently

Disable the creation of new remote support users. To enable the remote support user again you
must factory reset your system.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser DisablePermanently Confirm:
where
Confirm
: Yes
134
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.
Confirm