Xconfiguration Video Output Connector [2] Cec Mode; Xconfiguration Video Output Connector [2] Overscanlevel; Xconfiguration Video Output Connector [1; Xconfiguration Video Presentation Defaultsource - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

xConfiguration Video Output Connector [2] CEC Mode

The HDMI output (Output Connector 2) is for future use.
USAGE:
xConfiguration Video Output Connector
where
n
: Unique ID that identifies the video output connector. Range: 2..2

xConfiguration Video Output Connector [2] OverscanLevel

The HDMI output (Output Connector 2) is for future use.
USAGE:
xConfiguration Video Output Connector
where
n
: Unique ID that identifies the video output connector. Range: 2..2
xConfiguration Video Output Connector [1..2] Resolution
Connector 1: The resolution and refresh rate for the integrated display. This value is fixed and
cannot be changed.
Connector 2: The HDMI output (Output Connector 2) is for future use.
Default value: Connector 1: 1920_1080_60
USAGE:
xConfiguration Video Output Connector
where
n
: Unique ID that identifies the video output connector. Range: 1..2
Resolution
: Connector 1: 1920_1080_60
1920_1080_60: The resolution is 1920 x 1080, and the refresh rate is 60 Hz.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
n CEC Mode: Mode
n OverscanLevel: OverscanLevel
n Resolution: Resolution
xCommand

xConfiguration Video Presentation DefaultSource

Define which video input source to use as a default presentation source. This setting may be
used by the API and 3rd party user interfaces. It is not relevant when using the user interfaces
provided by Cisco.
Requires user role: ADMIN, USER
Default value: 2
USAGE:
xConfiguration Video Presentation DefaultSource:
where
DefaultSource
: 2
The video input source to use as default presentation source.

xConfiguration Video Selfview Default Mode

Define if the main video source (self-view) shall be displayed on screen after a call. The position
and size of the self-view window is determined by the Video Selfview Default PIPPosition and
the Video Selfview Default FullscreenMode settings respectively.
Requires user role: ADMIN, INTEGRATOR
Default value: Current
USAGE:
xConfiguration Video Selfview Default Mode:
where
Mode
: Off/Current/On
Off: self-view is switched off when leaving a call.
Current: self-view is left as is, i.e. if it was on during the call, it remains on after the call;
if it was off during the call, it remains off after the call.
On: self-view is switched on when leaving a call.
87
API Reference Guide
xStatus Appendices
DefaultSource
Mode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.