Xconfiguration H323 Nat Address; Macros Configuration; Xconfiguration Macros Mode; Xconfiguration Macros Autostart - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

xConfiguration H323 NAT Address

Define the external/global IP address to the router with NAT support. Packets sent to the
router will then be routed to the system. Note that NAT cannot be used when registered to a
gatekeeper.
In the router, the following ports must be routed to the system's IP address:
* Port 1720
* Port 5555-6555
* Port 2326-2487
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration H323 NAT Address: "Address"
where
Address
: String (0, 64)
A valid IPv4 address or IPv6 address.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration xCommand

Macros configuration

xConfiguration Macros Mode

Macros allow you to write snippets of JavaScript code that can automate parts of your video
endpoint, thus creating custom behavior. Use of macros is disabled by default, but the first
time you open the Macro Editor you will be asked whether to enable use of macros on the
codec. Use this setting when you want to manually enable, or to permanently disable the use
of macros on the codec. You can disable the use of macros within the Macro Editor. But this
will not permanently disable macros from running, because every time the codec is reset the
macros will be re-enabled automatically.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration Macros Mode:
Mode
where
Mode
: Off/On
Off: Permanently disable the use of macros on this video system.
On: Enable the use of macros on this video system.

xConfiguration Macros AutoStart

All the macros run in a single process on the video endpoint, called the macro runtime. It should
be running by default, but you can choose to stop and start it manually. If you restart the video
system, the runtime will automatically start again if auto start is enabled.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration Macros AutoStart:
where
AutoStart
: Off/On
Off: The macro runtime will not start automatically after a restart of the video system.
On: The macro runtime will start automatically after a restart of the video system.
50
API Reference Guide
xStatus Appendices
AutoStart
Copyright © 2017 Cisco Systems, Inc. All rights reserved.