Xcommand Call Farendcontrol Camera Stop; Xcommand Call Farendcontrol Roompreset Activate; Xcommand Call Farendcontrol Source Select; Xcommand Call Hold - Cisco TelePresence MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xCommand Call FarEndControl Camera Stop

Stop the far end camera after the xCommand FarEndControl Camera Move has been issued.
Requires user role: USER
USAGE:
xCommand Call FarEndControl Camera Stop [CallId: CallId]
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.

xCommand Call FarEndControl RoomPreset Activate

While in a call, this command is used to activate a preset on the far end codec. The preset
covers the far end codec's camera positions and input video switcher settings.
The preset must be stored on the far end codec beforehand, either by using the xCommand
Preset Store command locally on the far end codec, or by using the xCommand FarEndControl
Preset Store command from a remote codec.
Note: The far end codec's xConfiguration Conference FarEndControl Mode setting must be
switched On for the FarEndControl commands to work.
Requires user role: USER
USAGE:
xCommand Call FarEndControl RoomPreset Activate [CallId: CallId] PresetId:
PresetId
where
CallId: Integer (0..65534)
The CallId is required to identify the far end codec only when in a Multipoint call. The
CallId is returned when issuing the xCommand Dial command. During a call you can run
the xStatus Call command to see the CallId.
PresetId: Integer (1..15)
The ID of the preset that is stored on the far end codec.
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
D15335.02
About the API xConfiguration xCommand xCommand

xCommand Call FarEndControl Source Select

Select which video input source to use as the main source on the far end system.
Requires user role: USER
USAGE:
xCommand Call FarEndControl Source Select [CallId: CallId] SourceId:
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.
SourceId: Integer (0..15)
Select a video input source on the far end.

xCommand Call Hold

Put a call on hold.
Requires user role: USER
USAGE:
xCommand Call Hold [CallId: CallId] [Reason: Reason]
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.
Reason: Conference/Transfer/Other
Internal usage only.
96
API Reference Guide
xStatus Appendices
SourceId
Copyright © 2016 Cisco Systems, Inc. All rights reserved.