Cisco Ios Command Modes - Cisco ONS 15454 SDH Configuration Manual
Hide thumbs
Also See for ONS 15454 SDH:
- User manual (62 pages) ,
- Manual (40 pages) ,
- Reference manual (22 pages)
Table of Contents
Advertisement
Cisco IOS Command Modes
Step 9
After the new software load is activated on the node and all the non-ML-Series cards, you can activate
this load on the ML-Series cards by resetting the ML-Series cards.
Resetting the ML-Series card causes a loss of traffic and closes any Telnet sessions to the card.
Caution
To reset the ML-Series card through CTC, go to node view and click the ML-Series card to reveal a short
cut menu, click Reset Card.
After the ML-Series card reloads, verify that the correct software build is on the card using the Cisco
Step 10
IOS CLI privilege level show version command.
Example 3-1
version in bold.
Example 3-1
ML_Series# show version
Cisco IOS Software, ONS M-Series Software (DAYTONA-I7K91-M), Experimental Version
12.2(20050912:041138) [BLD-IOS_MARINER_MARINER_BF5_BUILD_6.amoayedi 105]
Cisco IOS Command Modes
The Cisco IOS user interface has several different modes. The commands available to you depend on
which mode you are in. To get a list of the commands available in a given mode, type a question mark
(?) at the system prompt.
Table 3-3
prompts. The system prompt helps you identify which mode you are in and, therefore, which commands
are available to you.
When a process makes unusually heavy demands on the CPU of the ML-Series card, it could impair CPU
Note
response time and cause a CPUHOG error message to appear on the console. This message indicates
which process used a large number of CPU cycles, such as the updating of the routing table with a large
number of routes due to an event. Seeing this message as a result of card reset or other infrequent events
should not be a cause for concern.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
3-16
shows a partial example of the show version command output with the Cisco IOS software
Output from show version Command
describes the most commonly used modes, how to enter the modes, and the resulting system
Chapter 3 Initial Configuration
Advertisement
Table of Contents
