Configuring The Pos Interfaces (Ml100T-12, Ml100X-8 And Ml1000-2) - Cisco ONS 15454 SDH Configuration Manual

Configuring the POS Interfaces (ML100T-12, ML100X-8 and ML1000-2)

pkts_error_giants
pkts_good_runts
pkts_error_runts
pkts_ucast
pkts_mcast
pkts_bcast
Rx Sync Loss
Overruns
FCS_errors
GMAC drop count
Symbol error
Rx Pause frames
MAC Transmit Counters
5d00h: %LINK-3-UPDOWN: Interface GigabitEthernet0, changed state to down
5d00h: %ETHERCHAN-5-MEMREMOVED: GigabitEthernet0 taken out of port-channel1
5d00h: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0, changed
staBytes
pkts64
pkts65to127
pkts128to255
pkts256to511
pkts512to1023
pkts1024to1518
pkts1519to1530
Good Giants
Unicast packets
Multicast packets
Broadcast packets
FCS errors
Tx Pause frames
Ucode drops
Example 4-6
Near_End# show controller gigabit ethernet 0
IF Name: GigabitEthernet0
Port Status DOWN
Port rxLosState No signal
Remote Fault Indication 00
Local Fault Indication 01
Port 0 Gmac Loopback false
Example 4-7
Far_End# show controller gigabit ethernet 0
IF Name: GigabitEthernet0
Port Status DOWN
Port rxLosState Signal present
Remote Fault Indication 01
Local Fault Indication 00
Port 0 Gmac Loopback false
Configuring the POS Interfaces (ML100T-12, ML100X-8 and ML1000-2)
Encapsulation changes on POS ports are allowed only when the interface is in a manual shutdown
(ADMIN_DOWN). For advanced POS interface configuration, see
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
4-10
0
0
0
0
5485
0
0
0
0
0
0
0
1952660
0
0
0
5485
0
0
0
0
0
5485
0
0
0
0
show controller Command Output for RFI on Near-end Card with Near-end Fault
(no error)
(link error)
show controller Command Output for RFI on Far-end Card with Near-end Fault
(link error)
(no error)
Chapter 4 Configuring Interfaces
Chapter 5, "Configuring POS."