Cisco ONS 15454 SDH Configuration Manual page 513

Appendix A Command Reference
show controller rpr-ieee interface-number [detail]
Use this command to display the status of the IEEE 802.17b based RPR controller. Use the detail
argument to obtain additional SONET and RPR-IEEE information for the interface.
Syntax Description Parameter
interface-number
detail
Defaults
N/A
Command Modes Privileged exec
Usage Guidelines This command can be used to help diagnose and isolate IEEE 802.17b based RPR or SONET problems.
Examples
router# show controller rpr-ieee 0 detail
Interface RPR-IEEE0
Hardware is RPR-IEEE channelized SONET
RPR Interface Defects:
EXCEED A0 RESERVED RATE: RINGLET 0 = 0
Active Alarms : None
Demoted Alarms: None
East Span
Framing Mode: GFP
Concatenation: VCAT
East Span Defects:
Active Alarms : None
Demoted Alarms: None
Alarms reportable to CLI: PAIS PLOP PUNEQ PTIM PPLM ENCAP PRDI PPDI BER_SF_B3 BER_SD_B3
VCAT_OOU_TPT LOM SQM
***************
VCG State: VCG_NORMAL
LCAS Type: SW-LCAS
Defect Processing Mode: IMMEDIATE
PDI Holdoff Time: 100 (msec)
Active Alarms : None
Demoted Alarms: None
DEGRADED
***************
ESM State: IS
VCG Member State: VCG_MEMBER_NORMAL
Description
Number of the IEEE 802.17b based RPR interface (0–1)
Greater detail per interface.
PROT ACTIVE = 0
(Ringlet0 TX Ringlet1 RX)
FS = 0 SF
WTR = 0 MATCH
LFD = 0 CSF
VCG ***************
= 1 DOWN
Member 0
PAIS = 0 PLOP
PPLM = 0 PUNEQ
BER_SF_B3 = 0 BER_SD_B3 = 0
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
MAX STATION = 0
RINGLET 1 = 0
= 0 SD
= 0 KEEPALIVE = 0
= 0 UPI
= 1 LOA
***************
= 0 PRDI
= 1 PPDI
BIP(B3) = 30
show controller rpr-ieee interface-number [detail]
MIS-CONF = 0 PASSTHRU = 1
= 0 MS = 0
= 0
= 1
= 0 PTIM = 0
= 0 PTIU = 0
REI = 0
A-37